24/7 Emergency · Se Habla Español · Bilingüe
Mobile Auto Electric · Albuquerque, NM

Your car won’t start? We fix it.

Keys, immobilizers, engine and transmission modules, airbag modules and the wiring behind all of it. The same van that cuts and programs keys carries the diagnostic and programming gear to put a car’s electronics right, at your house, your work or the side of the road. Call or text (505) 633-8247.

Service 01 · Keys & Immobilizers

Keys, remotes & immobilizers.

A modern key is half metal and half software. Cutting it is the easy part; the car has to be told to accept it. We cut and program keys, proximity fobs and remotes to the vehicle, including all keys lost, where there is nothing left to copy from and the key has to be built to the car.

Tell us the year, make and model when you call and you will get a straight answer on whether we can key it and what it costs, before anyone drives out.

  • Key programming
  • All keys lost
  • Proximity & smart keys
  • Remotes & fobs
  • Spare keys cut on site
  • Immobilizer diagnosis
Programming tool plugged into a vehicle on an ABQ Locksmith call
Key cutting machine showing key data
Service 02 · Module Programming

BCM, PCM and all module programming.

Body control, engine, transmission, instrument cluster. When a module fails, a replacement unit is not plug and play. It has to be programmed to the vehicle, matched to the VIN, and married to the immobilizer before the car will start and run properly.

We handle the replacement and the programming together, so you are not left with a car that has a new module in it and still will not turn over.

  • BCM / body control module
  • PCM / ECM replacement
  • All module programming
  • VIN setup & configuration
  • Module cloning
  • Immobilizer marriage
  • No-start after module swap
Working inside a vehicle on its electronics in Albuquerque
Programming tool plugged into a vehicle on an ABQ Locksmith call
Service 03 · Transmission Control

TCM programming & adaptations.

A transmission that shifts hard, hunts between gears or will not learn after a rebuild is often a control module problem rather than a mechanical one. A replacement TCM needs programming and the adaptation values reset before the gearbox behaves.

We program replacement modules, run the adaptation and relearn procedures, and check the shift behaviour before we leave.

  • TCM replacement
  • Module programming
  • Adaptation & relearn
  • Shift quality faults
  • Post-rebuild setup
Ignition and lock components laid out on a job
Working inside a vehicle on its electronics in Albuquerque
Service 04 · Drivability & Tuning

Engine and transmission tuning.

Calibration work for drivability and performance: engine and transmission tuning, shift points, and custom calibrations matched to what has actually been done to the vehicle.

Everything we write stays emissions legal. We do not remove, disable or tune out emissions equipment, because that is against federal law and it is the owner who carries the failed inspection.

  • Engine tuning
  • Transmission tuning
  • Shift point calibration
  • Performance calibrations
  • Custom tunes to the build
  • Tune ups
Programming tool plugged into a vehicle on an ABQ Locksmith call
ABQ Locksmith van open on a service call
Service 05 · Airbag & SRS

Airbag module repair and reset.

After a collision has been properly repaired, the airbag module usually still holds the fault that locked it, and the SRS light stays on until the crash data is reset or the module is replaced. We reset and repair SRS modules as part of a finished, legitimate repair so the system arms correctly again.

A working airbag is a safety system, not a warning light to be cleared. We will not make a light go out on a car whose restraint system has not actually been put right.

  • SRS / airbag module reset
  • Crash data reset after repair
  • Module repair & replacement
  • Post-repair system check
  • SRS warning light diagnosis
Working inside a vehicle on its electronics in Albuquerque
Ignition column opened up during a repair
Service 06 · Electrical Diagnosis

No start, wiring & electrical faults.

The car that cranks and will not catch, the one that is dead on a Monday, the intermittent fault nobody has been able to pin down. We trace it properly: battery and charging, starting circuits, fuses and relays, grounds, and the wiring between the modules.

Mobile, so the car does not need a tow to be looked at, and you get told what is actually wrong before any parts get bought.

  • No-start diagnosis
  • Wiring faults & repair
  • Fuse & relay diagnosis
  • Battery & charging system
  • Module communication faults
  • Intermittent electrical gremlins
Ignition column opened up during a repair
ABQ Locksmith van open on a service call
Coverage

Most makes on the road here.

Chevrolet, Ford, Toyota, GMC, RAM, Nissan, Honda, Kia, Hyundai, Dodge and plenty more. Coverage depends on the year and the module, so call with the year, make and model and you will get a straight answer before anyone is dispatched.

  • Domestic, import & truck
  • Petrol & diesel
  • Mobile across Albuquerque
  • 24/7 for no-starts
ABQ Locksmith branded mobile service van
ABQ Locksmith van open on a service call
Mobile · 24/7

Dead on the drive? We come to it.

Tell us the year, make and model and what the car is doing, and you will get a straight answer on whether we can sort it and what it costs.

Call (505) 633-8247 Service Area